1-805-484-2992
Quotes - Engineering - Sales
Unit pictured is representative of the series; dimensions and connections vary by part number - see the table below.
Construction
Body
- Heavy-gauge fabricated steel with 150# flanged connections from 2-1/2 to 10 inches. Stainless steel available.
Internals
- Fixed impeller and baffle identical to the horizontal range, so performance figures carry across size for size.
Connections
- Inlet and outlet are the same size through the S06V; from the S07V up the inlet is one size larger than the outlet to keep entry velocity down.
Drain
- Bottom sump with a threaded drain for the SAC120 (S04V-S07V) or SAC100 (S08V, S09V) trap.
Why a vertical separator
When the pipe goes up, the separator should too
- Side inlet, top outlet - no extra elbows
- Smaller footprint than the horizontal equivalent
- Same capacity ratings as the matching S-H size
Vertical Separators Part Numbers
| Part Number | SCFM | Height | Width | Dim C | Inlet | Outlet | Weight | Drain Trap |
|---|---|---|---|---|---|---|---|---|
| S04VAUH0 | 900 | 37-1/8" | 13-1/16" | 31-7/8" | 2-1/2" FLG | 2-1/2" FLG | 64 lb | SAC120 |
| S4AVAUH0 | 1,400 | 39-5/8" | 13-3/4" | 34-3/8" | 3" FLG | 3" FLG | 86 lb | SAC120 |
| S05VAUH0 | 1,500 | 45-1/2" | 15-1/8" | 39-1/2" | 4" FLG | 4" FLG | 132 lb | SAC120 |
| S06VAUH0 | 2,800 | 48-5/8" | 18-1/8" | 41-7/8" | 5" FLG | 5" FLG | 175 lb | SAC120 |
| S07VAUH0 | 3,600 | 51-1/8" | 20-1/8" | 43-1/4" | 8" FLG | 6" FLG | 225 lb | SAC120 |
| S08VAUH0 | 3,900 | 55-1/8" | 21-3/4" | 46-5/8" | 10" FLG | 8" FLG | 330 lb | SAC100 |
| S09VAUH0 | 5,800 | 58-7/8" | 23-3/4" | 49-3/8" | 10" FLG | 8" FLG | 380 lb | SAC100 |
Capacity is at 100 PSIG. H is overall height, W the body width and C the inlet centreline height, in inches. Drain Trap is the recommended IPAC SAC model.
Applications
What We Need to Quote
A selection comes together quickly once the duty is stated.
- Compressor SCFM and pressure, or the heat load
- Inlet temperature and the cooling water or ambient temperature
- Required outlet temperature
- Design pressure and any code stamp
Replacing an Existing Unit
Where a unit is being replaced, the nameplate does most of the work.
- IPAC or HiROSS model number, exactly as stamped
- National Board number where one is fitted
- Connection sizes and orientation
